Bulkhead fitting for Prusa Enclosure - UPDATED

Replacement top caps on the Prusa enclosure, which uses M10 4mm OD PTFE Tube fitting both inside and out

31m

1× print file

0.20 mm

0.40 mm

5.00 g

183

updated March 6, 2023

Description

UPDATED: to allow easier feeding of filament through, now has inner guide and stop for PTFE tube.

Just a bulkhead fitting for the Prusa enclosure, to allow PTFE tube to pass through

Uses M10 4mm OD fitting both inside and out.

prints with supports, there is also a snap off support, which needs to be removed, before you can install the inner fitting.

The author marked this model as their own original creation.