Improved Dust Shoe for LowRider 3

This dust shoe fixes two of the main problems the original one had: very slight rattling as well as not sucking up all the dust when planing MDF or cutting acrylic. 

The dust shoe features a small gap for thin PVC or similar material, the holes for the magnets are for 5x4mm ones.

You can steal the skirt from your kitchen table cover. Don't tell your wife.

Prints with the recommended settings for the LowRider 3.

Update 19.08.: I added printable bristles made from TPU. They have a gap at the top and bottom (the bottom one is needed because that's the place where the Makita draws air, they are getting sucked into the collet otherwise).