Knurled PC4-M10 PTFE Drybox filament pass through

This is the version of the drybox feeder insert for using PC4-M10 fitting with the M10 x 0.9 thread. For the PC4-M6 version get the original design by RoboMagus (linked below).

This pass-through adapter for a makeshift drybox solves several problems:

1. It spreads the load over a larger area, so the thin wall of the plastic box is less likely to crack.
2. No need for a nut.
3. No need for wrenches to install or remove.

Link to the Fusion 360 file:
https://a360.co/3ixBAuY

Print instructions

I printed this in PETG at 0.2 layer height, because I wanted the thread to print nicer.