Voron Rollback Stands

This version is one piece, with thicker compression and tension caps to improve rigidity. I changed the shear web area to more closely resemble Voron's standard honeycomb pattern and added a built-in support.   You will need to remove and toss the print-in-place support.

With these installed, you can roll your Voron onto its back and access the electronics bay underneath.  These will replace the rear lower corner and midspan panel clips.

Edit 4/18/23:  Rotated the honeycomb pattern to match the Voron pattern better.

For the most part, this was created from scatch.  It was inspired by the RockNLol model listed above, and looks very similar.  Pretty much every dimension on this will be different than his.

It is designed to fit the Voron dimensions, as per the manual.  I have included a version with additional clearance, should anyone want to use this with 3mm tape on the back panel.