Remixed Minnowboard Turbot Dual case

I remixed this case to fit a MinnowBoard Turbot Dual Ethernet.

I fixed the location of the holes a bit. This should fit now.

Added a lid version with hole for heatsink (e.g. 38x38x30mm).

Post-Printing

Assembly

Four short PC screws used for HDD mounting are needed to secure the board to the bottom tray.

Four**M3 x 25 mm** bolts need to assemble the example bottom and example lid. Insert them through the bottom and screw them directly into the lid. This uses the bolt heads as stand-offs. Category: Electronics