Time Stories card organiser

I wanted some way to contain all the Time Stories expansions in the main box, but unfortunately all other solutions I found used about a metric ton of plastic and could often not accommodate all ten missions in the white cycle.

This design is very basic and uses thin walls to print fast while still being rigid enough to hopefully not break with careful handling. The cards can be a bit tricky to get into and out of the individual compartments, so you may have to fiddle with it a bit. Unpacking all loose components between the card holders will allow you to push an either quarter section slightly towards the middle and this should help.

This also only organises the cards and leaves you to organise the rest of the game as you see fit. I think ziplock bags are good enough.

It also extends above the cards enough that it helps support the lid with enough room for the manual and the board. This is by far the weakest point and these supports may break far too easily.

The design is made for 0,4mm nozzle but I used a 0,6mm with 0,35mm layer height to print faster. I printed it in PETG.