Alternate Mounting Hardware for printed Skadis Panels

This is an alternate mounting solution for Asraff Amzani's Modular Skadis Panel. Seen here: https://www.printables.com/model/19442-modular-skadis-panel

The intent is that the “half” mounts below slide onto the tops and bottoms of a given set of panels, and the “full” mounts link panels together vertically. though you could use 4 “half” mounts to hang an individual panel if you so wished. A hole in each part is to accommodate a woodscrew.  I used 1 ½" woodscrews as it made sense for the cabinet I was attaching my panels to, but note the length you need before attempting to hang your panels

The goal was to leave as much of the skadis panel useful, and to not obstruct more holes than necessary when the part is hung.

Unfortunately this mounting solution does not work with actual ikea branded panels, though I am considering making a revision that can be used with them. 

Autocad file available upon request.

I recommend printing at high infill, if not completely solid so that screws don't cause the print to compress and crack.