Bic Lighter Case Keychain - South Park Towelie

I have no idea what's going on. You might be interested in my other Bic Lighter Case designs!

My settings are 0.1mm layers, 3 walls, 5% infill, and no supports needed.

The fit is very snug so that the lighter will not fall out. There is a hole in the bottom to help remove the lighter when it's time to change it out. While printing you may want to pause and add your keychain or jump ring, or you can twist them on later. 

Tip: Remove the label on the lighter with a blow dryer or heat gun to make it easier to insert, and so that the label won't get shredded while inserting it into the case.

Note: This fits a standard Bic lighter without a plastic, shrink wrap design.

Wait… What were we talking about…You're a towel!

Need a quick print to test your first layer?

Are you interested in selling your prints of my designs? Join my Printables Club, and start making 💰 with your idle printers!