A pocket door strike with latch receiver, since I could not find any that were not part of packs with new latches.
FreeCAD and OBJ files included for customization. Screw holes sized for drywall screws (1-1/4" x 6) since I had those already. May need adjusted for other screw types. Also check your tolerances for your pocket door latch.
PLA should work, but I used PETG with 40% infill and was very happy with the strength.
A pocket door strike with latch receiver, since I could not find any that were not part of packs with new latches.
FreeCAD and OBJ files included for customization. Screw holes sized for drywall screws (1-1/4" x 6) since I had those already. May need adjusted for other screw types. Also check your tolerances for your pocket door latch.
PLA should work, but I used PETG with 40% infill and was very happy with the strength.
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: 0.2mm
Infill: 40
Filament: Amazon Basics PETG
The author marked this model as their own original creation. Imported from Thingiverse.