Been wanting a better poseable worklight. Found out that the Sofirn SC21 can run while plugged into power, so I printed a mount that snaps onto Loc Line (½" ID Loc Line) and holds the light. It has a gap for the pocket clip and the rubber charging cover, so they stay attached. Also has a passthrough gap for the USBC charging cable so you can either use it while plugged into power or unplug it temporarily.
I made a weighted base of of a chunk of steel and some magnets and pipe fittings I already had but a base could easily be printed.
Print right side up with no supports. May require a brim to ensure the print sticks to your print bed. I printed it in PLA but PETG might be better. I printed it at 60% infill. It took a few tries to get the fit onto the Loc Line perfect, the model I uploaded was my final successful attempt. If yours is too tight/loose you might need to scale the model slightly in the X/Y direction.
The author marked this model as their own original creation.