Comical and Edgy Bad Parking Job Award/Handout - Business Card/Wallet Size For Easy Placement (zip tie holes for fun)

THE NEWEST ADDITION IS FINALLY HERE: https://www.printables.com/model/704603-night-raids-ultimate-karambit-knuckle-duster-fully

go show some love!

Thirsty? Print your own dragon themed chalice here:

https://www.printables.com/model/403847-medieval-dragon-embroidered-goblet-chalice-game-of

Or need the ultimate Tanto? Check out the latest version here!

https://www.printables.com/model/418227-the-ultimate-tanto-blade-styled-combat-knifeshort-

________________________________________________________________________________________________________________

As the description states….

Perfect little wallet sized card to leave for your favorite XXL 2-seater car who somehow occupies 2-3 spaces in a parking lot. 

Use it for fun, be serious with it, all that matters is you have a good time. Maybe it'll make a few people reevaluate their parking choices in the future? who knows? 

As an added bonus I put in 2x 3mm holes in the bottom of each card just in case there's a windy day and you want to be sure you can zip tie down that important message you just left (we wouldn't want it blowing away now would we).

The only way to find out how much fun you can have with it, is for you to download it today and share your experience and make here :)

ALWAYS PRINT ON DETAILED MODE AND COOL YOUR HOTEND IF YOU GET ANY STRINGING!

Now onto the good stuff:

• No supports needed
• Print on flat back (better windshield adhesion, no risk of scratching paint or any surface this may be applied to or attached to.
• I take no responsibility for how this is used or the outcomes it provides - be it positive or negative. (some people today just cant take a joke, but really now 3 series owners… stop parking across 4 spots at the grocery store, you just increasing your chances of getting hit by a cart…
• 2 little 3mm holes on bottom left and right to hold placard onto windshield wipers or wherever your zip tie is long enough to get into because we all have a few too many spares that came with the prusa kits. 

- For PLA: 

Print at 58-62 degree bed temp - 80% speed first layer - 20% infill or less is fine - 213-215 hot end temp. resume speed to 100% after first layer. (IF YOUR PLA IS AMO. OR ONE OF THE OTHER MAJOR BRAND HOT END SHOULD BE AT 225-230 FOR OPTIMAL RESULTS SAME BED TIME AS MENTIONED HERE)

- For Prusament PLA: 

Print at 62-64 degree bed temp - 80% speed first layer - 20% infill or less is fine - 220 hot end temp. resume speed to 100% after first layer.

- For PLA+ (esun/sunlu):

Print at 65 degree bed temp - 80% speed first layer - 20% infill or less is fine - 210 hot end temp. resume speed to 100% after first layer. (max hot end at 215 if struggling with ambient temps outside of enclosure.