Original Prusa Enclosure (OPE) Back Widow Left Edge Plug with Cord Pass Through

I needed a way to get a cord out of the back side of the Original Prusa Enclosure. After removing the small cutout on the left side I felt it needed something to cover up the hole. So, since DesertStorm's plug for the top of the enclosure fit nearly perfectly I remixed it to fit the shape of the removed cutout. I also had to move the rivet hole back just a bit to line it up properly. 

This print fits like a glove, so be sure to carefully remove the extra plastic bits left behind when you remove the cutout. 

This could also be used on the right side by mirroring the print. 

Created this to cover the triangular cut outs on the rear side of the enclosure.