PrintedSolid Pulse enclosure spool mount

I was tired of the perch spool mount on my Pulse XE that would not let the PrintedSolid enclosure door close fully. I was inspired but the remaining spool arm left after I assembled my Original Prusa Enclosure, so I made this. PrintedSolid is not very repetitive in their cut out locations, so your use will need to be measured. Bayonet mount arm is solid.

You need:

2 M3 nuts, and 2 M3x12 machine screws

2 M5 nuts and 2 M5x12 machine screws

1 M5 Push connect to the tubing size you need. The filament path off the spool is 2mm though.