Hex Driver Key (updated 19/04/2022)

Hex Driver Bit Holder

I designed this for attaching/removing camera quick-release plates. Keep it on a lanyard round my neck rather than searching through a camera bag or pockets for a bulkier screwdriver. Or you could tie it to a tripod leg, etc.

Update (19/04/2022):

Finally got round to adding the lanyard/ keyring hole (should have had this feature originally).  The photo is of the original without the lanyard hole but otherwise identical.

Print instructions

Prusa i3 Mk3sS

Prusa PLA, PETG, etc

0.20mm SPEED (modified)
Could add a support for the hole - or just sand it smooth after printing
Infill 20% or more
Brim 3-4 mm

Post production:
Remove brim and sand/trim
Use a flame to remove any stringy bits

Push any standard hex driver bit into the top hole