Kitchen sink remote control replacement part (Blanco)

This is a replacement part for the inner part of a remote control of the Blanco Elon kitchen sink. You can find this part and the corresponding parts with the item number 119 293 for about 18€ or you can just print this part. I created this part as the original one broke and I didn't want to spend 18€ for the replacement. Hope somebody can use this at some time :)

It was easy printing the part with the smaller outlet at the bottom, using supports. 

Recommended print settings: Infill 15%, support on build plate, layer height: 0.20mm. I used Prusament PLA Galaxy Black - see pictures.

Update v2: As v1 broke inside when tightening the remote control after some time, I decided to fill in the gap as there is no use for it anyway.