Wall-Mount Torch Lamp - socket B22

The original model is great, but I have B22 sockets so I had to adapt it.

A few other changes :

• Cover may be fastened to the base plate with M2.5 and hex nuts
• Cover has an internal groove to fix the glass, so it may be used “pointing down” 
• Glass is longer by a few centimeters, since B22 light bulbs are longer than GU10
• Glass as an added notch to clip into the cover's internal groove
• Glass is no more open-ended

Note you will have to shorten two of the “legs” of the glass, otherwise it will not go fully into the cover (same problem with original model) : a small part of the backplate blocks those two legs.

Backplane and glass should be printed in PETG ; cover may be printed in PLA or PETG.