Hard Boiled Egg Chopstick Holder

Hard Boiled Egg Chopstick Holder

A hard boiled egg chopstick holder for two. 

Please feel free to remix this as you please. I've also included the .f3d. All I ask is that you give me credit as the original creator. Also, if you end up printing this, please share some photos of it and let me know what you think!

Fusion 360 Preview (with Chopsticks): https://a360.co/3xtEUjK

---
Print Settings

Everything was printed with a 0.4mm nozzle, 0.2mm layer height, 15% infill (Base and Egg Whites) or 35% infill (Yolks) at 250mm/s on an AnkerMake M5. No supports or brims are needed. Each of the .stl's are oriented properly and should be ready to be sliced and printed.

Adhesion Issues?
Try printing with a 8-10mm brim. 

Quality Issues?
Try printing at a slower speed (start decreasing the speed by 10-15mm/s). 

---
Part List

There are six parts overall, but I've broken up the .stl's by color to make it easier to print.

White

• Egg Base and [2x] Egg White.stl

Yellow

• [2x] Yolks.stl

---
Filament Used

---
Instructions

1. Print the parts
2. Put the smaller of the two Yolks into the smaller Egg White
3. Do the same for the last Yolk and Egg White
4. Put both assembled Egg Whites and Yokes into the Egg Base
5. Put a set of chopsticks into the holes on the base