Spooky-Switch

Based on this Design: https://www.prusaprinters.org/de/prints/39447-spooky/files

I like the Spooky very much, but I wanted an easier way to switch it on and off and to change the battery.

Print instructions

You also need:
A battery holder of the type Renata VBH2032-1 and a small DIP switch with the dimensions 4.0mm x 9.9mm x 5.3mm and some wire

Assembly step by step:

1. The contacts of the battery holder should be shortened a little.
2. Solder the wire to the switch and the battery holder
3. Insert both parts into the base
4. Put the LED in the holder
5. Insert the battery
6. Check polarity of connections
7. Glue the LED holder to the base
8. Carefully solder the cables
9. Put the base in the thread. Attention! The smooth side must be up!
10. Screw the thread into the Spooky.