Hook Saver

I made this from an idea I had to save the points on my fishing hooks as when I break down at the end of a session I usually remove the weight and put the hook over the eye of the rod then wind up and put away in my bag, this leaves the hook exposed and can easily get blunt or stick you when you take the rods out next. This is printed in petg with minimal supports under the hook end. Printing upright doesnt work. Once printed I got a piece of foam slightly wider than needed and pushed it into the slot as far as it will go then cut the surplus off leaving 1 or 2 mm over. with a small screwdriver or scissors pushed this in till flush. To use put your hook into the foam and hang the hook piece over the eye of your rod this will stop hook scratching anything and save the point.