TP-Link Tapo C200 / C210 inverted camera mount

TP-Link Tapo Camera Inverted Mount

This is a remix / mashup of Kadows' upside-down Tapo camera stand and Cewo's Tapo base (https://www.printables.com/model/377139-tapo-base-c210).  

Design

I printed the orignal but found that the stand was too weak and flexed, so I redesigned it to stronger and have better attachment to the holder.  

I also didn't want to use screws etc, so I mashed up the holder with Cewo's tapo base so that no additional hardware is required to mount the camera.  I also cut away the area under the tabs so as to make it easier to remove supports.

Printing

I printed with PLA at 0.2mm layers and 15% infill and found it to be strong enough.  Supports are only required under the tabs where the camera attaches.