Wire Organizer Connections

I had the need to create a few more connectors for my wire organizer and decided to also make half and quarter variants since I was not a fan of the protrusion past the organizer with a single-size connector.

Gcode File Settings:

• Layer Height: 0.2mm
• Infil: 100%
• Print Temp: 220 °C
• Plate Temp: 40 °C
• Speed: 60mm/s

Additional Settings:

• Combing Mode: On - All
• Supports: On
• Support Type: Tree
• Support Infil: 5%
• Build Plate Adhesion: None (I did not have any adhesion issues on PEI Glass Plate)

Quarter Piece:

• Material Use: 8g
• Time: 1:09

Half Piece:

• Material Use: 12g
• Time: 1:41

Full Piece:

• Material Use: 16g
• Time: 2:26