This model is designed to magnetically connect an ultra fine mesh bag to the exhaust of the Aillio Bullet's cooling tray, to allow catching fine particulate and any chaff. Magnets attract to the screws used by the cooling tray fan.
Uses standard 3x6mm round magnets. Magnets should be a light press fit and should self-retain. If fit is loose, use a dab of superglue to secure.
Bags used in photo are: https://www.amazon.com/dp/B0B2LL4NC8 however, any ‘200 mesh’ (200um) bags used for nut milk should work fine. Alternatively, a hose could be connected with hose clamps if exhausted outside.
Use tree supports from either PrusaSlicer 2.6+ or Cura to print this model, as the overhangs used to retain mesh bag cord are not printable otherwise.
The author marked this model as their own original creation.