Dual XT60 Cap for LiPo Battery

A remix of the XT60 caps and the good lookin' organiser by Michał Trybus.

When printed in different colours, these dual XT60 caps not only help protect the LiPo battery terminals, but also gives you a way to organise your collection of batteries:

• one colour (green) = fully charged
• one colour (black or yellow) = storage charge
• not use = discharged (caps can then go to the organiser)

Printing

• I printed these caps successfully in TPU95A and they fit snuggly on my LiPo battery XT60 terminals.
• Set colour / filament change at layer 76 / 9.20 mm on your slicer.
• You will need to add support on the bottom end of the flat surface. You will need quite a bit of force to rip the supports off with a plier, but the cap will stay unharmed.

Happy flying! (Or whatever you are using your batteries for…!)