Wheel adapter for BambuLab X1

I mounted the Bambu Lab X1C in a pretty narrow place where it is difficult to reach behind the printer. Therefore I need to pull it out everytime I need to check the back of the machine, this way wearing prematurely the rubber feet and also leaving marks on the floor.

So I designed a mount for 30mm rubber padded wheels that are easily found in hardware stores. The mount has 3mm high grooves in order to stop the wheel to turn and be able to push-pull the printer in a straight line.

You need to remove the rubber feet, that are held in place with sticky tape. Just pull away the feet with your fingers, no tools required. Than just push the adapters in place, lined with the inner walls of the printer.

In order to attach the wheel to the mount/adapter, you will need 2 pieces of 3mm screws and 2 nuts. Optionally you can use washers. I just used whatever I had at hand, beacause nobody will look there! :)