Prusa Mini Gaming Edition: Slot Cover

Want to make your Mini fit your gaming setup? Than this is the right print for you: Cover up the slots in the aluminium extrusions and put some LED-stips over it to make it shine.

What you need:
-Slot covers in the lenth of the aluminium extrusions
-RGB-LED-strips
-Power Supply and controler for LED-strips (often included when buying strips)
-probably some splitter cables

What you do:
-Print the slot covers (the model has a length of 50mm; you need ~250mm for each y-axis or z-axis slot)
-Put the covers into the slots
-Put LED-strips over it
-Connect the stips to the controller
-Connect the powersupply

Note:
You can also use these covers just to cover the slots to reduce debree in them.
If the covers are visible, I suggest printing them in black or orange, to match the colours of the printer.

Warning:
Do not cover up the hole slot if you ever want to remove the covers again! (I recommend a gap on one side of at least 10mm)

I appologise for my paint skills.