Resin Keycap, infill arrow (cherry MX)

Print in clear resin

When printed, cure and wash good! 

Fill arrow with desired color resin, and cure again.
Use a syringe with dull needle, start at arrow tip hole, and let it vent throu the other holes.
 

When filled, clean the insides of  the keycap.
If desired you can paint the inside with nailpolish/resin to make “background” color. 

Apply a layer of clear resin all over upper sides, and cure again, for polish finnish.

V1.1 = outer crosswalls 5degree, more printable flat(arrow up from bed) at bed with sla printer
 
I did not have right equipment. The only “color” i had was grey. could have performed better.