Ender 3 V2 Mounts for Raspberry PI Snap-Fit Case

This is a remix of Sneaks' Modular Snap Together Raspberry Pi 2B/3B/3B+/4 Case w/ OLED & Fan Options mounting brackets, to attach to an Ender 3 V2's rails without requiring any screws.

This slides onto any ‘RAIL’ compatible Raspberry PI Cases from his model.

Printing instructions:

• Infill: 10%
• Nozzle: 0.4mm
• Layer Height: 0.3mm
• No supports

Assembly:

• Attach the mounting brackets to the Raspberry PI's case (to be slid on from both sides and will click into place)
• Remove the cap at the end of the Ender 3 V2's mounting rails (sometimes requires a bit of force - be careful as the ends of the rails are sharp - speaking from experience)
• Slide the mounting brackets now attached to the Raspberry PI, onto the Ender 3 V2's rails.
• Push the clip back on the Ender 3 V2's mounting rails back into place.

Printed in GEEETECH Black PLA.