P1P Cablechain Ultimate Anti Sagging Kit (UASK)

I got tired of watching the Amazon cablechain drops lower and lower just before it hits the carbon rods.
So I thought about how to prevent that. The solution is to change the angle at which the cablechain is mounted on both sides.

In this kit there is everything you need to get the cable chain straight and presentable without any Cable ties or else.

This kit consists of several modified parts from other Printers:

1. Frameadatper from Tr1ckSilv3r

2. Cablemount & Tubeclip from MediaMan3D

3. Tubeguide from Adam L (not modified)

-----------------------------------------

Remarks:

-The Cablemount should be print with automatic tree support. This Version got extra thick angled tabs.
-The mounting position for the cablechain on the Frameadapter is a little bit more to the left, with an angle that you cant see with the eyes until the cablechain is mounted.
-The Tubeclip is modified so that it doesnt hit the P1P Frame when the cablechain goes far to the right. And also it doesnt hit the screw if you have the ARC housing.
-The Tubeguide is perfect from Adam L how it was.

-I used 23 Chainlinks in total (without the mounting piece)
-The Tubeclip should be mounted that the Tube is on the inner side. One mounted on the 10th link should be enough.