Linear Table Designed for smart reloader 3000 shooting front rest

Linear Table Designed for smart reloader 3000 shooting front rest but could have other uses. 
 

100% would be better milled, but use the tools you have! 

There are a couple of different base options :

• one is the one with clips designed to clip directly on to the metal plate on top of the rest but I found the clips can be a little brittle and snap
•  one is flat so could be used for anything, bolted straight to the mount or drop some little magnets in there during printing to latch it onto the rest top.
   

You will need:

• two pieces of 8mm rod 150mm in length 
• one 8mm threaded bar approx 180mm in length
• two M8 locknuts  
• one M8 standard nut (drops into the tabletop slot) 

plus a couple of little Allen lugs or something if you want to lock the rails in place (I am not sure it needs it) 

The conical adjuster isn't great but it might have just been a bad print. 
It was designed so the table top could move the full distance both ways, but for bench rest shooting it only really needs to go further one way so I just set it up that way 

I printed it on 0.25mm draft and it works just fine
 

I've included a 3mf with all the all the bits and the base with clips on it with supports everywhere, this is the most efficient way I have found to print it. The base without clips could simply be printed flat 
 

If you like it then please feel free to Buy me a coffee: https://www.buymeacoffee.com/575860607070