Extra spool holder for Prusa Enclosure

Miror of the spool holder in the enclosure box so it can be installed on the bottom right corner of the enclosure (right under the first spool holder). Allows 2 spool inside the enclosure and ensure smooth color change.

This is the very first version of this design. The spool is very low for now and you must push back the print bed to insert/remove the spool on the holder.

If you want a easier acces holder, use Kevin's remix to have a longer arm.

To install, follow the same instructions as for the original spool holder (steps 36 to 37) in the enclosure manual. You will need:

• 2x M3x12 screw
• 2x M3n nut
• 1x side arm

This extra spool holder fits right in the Prusa Enclosure under the original one (bottom right corder).