Vacuum Canister Door Latch

This is a replacement latch for the debris canister on a Eureka RapidClean Pro cordless vacuum cleaner. Ours gets used on a daily basis and after a while the latch loses it's ‘springiness’ and doesn't always close right. So I designed a replacement. 

This one prints in about an hour at .1 mm layer height. I recommend using as small a layer height as you can as it is a pretty small object with a few fine details.

Supports (on build plate only ) are recommended on the main latch piece and a brim is recommended for the spring. 

A dab of glue is optional to hold the spring into the slot on the latch.