Artillery Sidewinder x1 X axis cover

This is The best X axys cover for Artillery x1.

So... to print it you just need filament and a printer ;P

this dont need screws or some extra parts....

my artillery i guess is the V4 because i have it since two months.

The orange cable is my 3dtouch.

Print Settings

Printer:

Sidewinder x1

Rafts:

No

Supports:

No

Resolution:

0.3

Infill:

15%

Filament:

Notes:

i printed Chinese Pla and with 0.6 volcano nozzle 65mms and 0.3 layer and it looks good.
please notice that you need to turn the model in cura and you dont need any support.

Post-Printing

Why a full cover without screws?

i decide to design this cover because every single cover i found in thingverse was useless for my point of view, i dont want something only because it looks nice i want something usefull.
So i decide to print some cover that protect the cables from the mouth of my cats and also to protect from the from dust and hair( unfortunately i have no special place for the printer ).

To print you just need to rotate the cover in cura and print it.

to assemble on the printer i did the design the most efficient possible, you dont need to disassemble anything.

Just put and push the cover it will fits perfectly.

i also have the cover for the left and right cables of the Z motors ASAP.