BEER BOTTLES CARRIER

The carrying container is designed for 6 bottles with a diameter of 63 mm max and a height of 25 cm. The carrier is made of PLA (+) and and has of 5 parts:

Please note the attached gcode files for best results as for supports on the Top Arm edges and avoiding bridges on the Main Body.

I used 0.20 mm SPEED mode and 20% infill on all parts, except for the Arm Screw where I used 30% infill.

Main body  One (1) unit. This is largest file to print, about 35 hours.  

Arm Side      Two (2) units

Arm Screw   Two (2) units 

Top Arm         One (1) unit

Cap Top          Two (2) units

The assembly tested for full carrying weight and size.