Resealable Pouch Filling Assistant - No Supports

This handy little tool helps refill those refillable baby/toddler food pouches without needing three or four hands. These are the pouches I use them with but I think all the caps are roughly the same size so it should work with most brands. I've also included little C-clips which hold the pouch open while you're filling it just to make it that much easier. See the pic I posted for how it works. 

As far as printing goes, I just printed them as rough and fast as possible in PLA. 0.2mm+ layer height (I think I did 0.3mm layer height with a 0.6mm nozzle) with 15% infill. It prints in the same orientation as it's used and I tried to round everything as much as possible to cut down on print time.