Print Savers (anchors for corners)

During printing I'm finding some of the sharp corners are lifting off the print bed. These anchors will help with adhesion to the bed on the first layer.

I currently have six files in here (1.25cm x 0.10mm, 1.25cm x 0.15mm, 1.25 x 0.20mm, 1.5cm x 0.10mm, 1.5cm x 0.15mm, 1.5cm x 0.20mm). Use a height that matches your first base layer then slide them onto the corners of the model as shown in the one photo. 

If you should need additional sizes, let me know and I can likely add some additional sizes to this file. 

I've used these on a couple prints now and they seem to help but I'm always happy to hear feedback. 

Thank you and happy printing!