Ikea Pax Sliding Door Pull

My Ikea Pax cabinet with glass sliding doors is installed flush against a wall on the right hand side, making it hard to open and even harder to fully close tight.

So I designed this snap on pull. It fits tight and secure without needing any screws nor glue; just snap in place and it's so much easier to open AND close the sliding door!

Pics are of a right-hand pull… the file for left and right are different; the small tab on the inside bottom is designed to slip into the small gap on the top side of one of the mullions on the inside of the door. Flex the pull and insert this small tab first (see pics), then continue to flex/wrap the pull around the door edge until it snaps in place.

Printed in PETG w/15% rectilinear infill. I used a 5mm brim, no supports (ensure small tab in on build plate). Other materials and settings may work just as well or better. YMMV

If you like my model and have found it useful, please support my filament addiction- https://www.buymeacoffee.com/skyguy