Pod Walker

Hi!

This is another robot/mecha/walker ready to print in parts then assembled.

Choose your favourite colour combo and print!!

Using the same pilot that i made for 'Tow Walker' (https://www.thingiverse.com/thing:2893106)

Tolerances around 0.2 mms so you shouldn't need sanding. If some parts comes loose when assembling my best tip is using a bit of tape (see below) to made a strong fit.

I could print at 50% (in 5 hours) and it works!!

Include a full-plate.stl with all the parts ready to print-in-place (fits in a 18x18 cms plate). Also there's 2 files 'full-color1.stl and full-color2.stl with the parts i've print in diferent colors

Just in case i included a 'robot.stl' with the full figure in a piece.

NO SUPPORTS NEEDED!!! :D

Hope you like it.

Have fun!!

Using tape for a good fit

if some parts comes loose, use a bit of tape to make a good fit

All the pieces

My first color selection parts

My second color selection parts