Wooden Barrel

After creating my wooden chest (http://www.thingiverse.com/thing:1917674) there was some Laywood Filament left over. So I created a barrel and printed it, the last three or so layers failed die to run out of filament...

This is a bit work in progress, I think the wooden structure needs to be a bit more, or a better printer is needed. So I again carved the details a bit and painted the iron rings black with a pencil. The barrel needs support on the bottom.

I added a High Res version, see the names with HR in it. This one also has the planks on the bottom and a plug.

Print instructions

Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: Model Furniture Print Settings

Printer: Velleman k8200

Rafts: Yes

Supports: Yes

Resolution: .24mm

Infill: Cubic

How I Designed This

Blender of course

I started with a simple mesh and used the Subdivision Surface Modifier. Then I added a texture of wood and use a Displace Modifier to change the mesh according to the texture. Then I added iron Rings via the Boolean Add Modifier and modelled some planks to close it.