Remix of Bambu Labs X1 POOPY SHOE - added magnets (10*5 mm)

Added holes for magnets, so it's easier to snap it in place in the blind, if the printer is placed up against a wall.

Also, I cut of a tiny bit of the curved edge where the heel meets the slope, to make it print nicer without supports there.

You could add a modifier to add support enforcers for the magnet holes - but it will probably be fine without.
I printed mine with support in the holes, and my 10*5 mm magnets fit in perfectly, didn't even need to use glue.

Should fit the Bambu Lab P1P as well.

Note: It can be a bit tricky to make it fit the build plate - position it like shown in the picture, then right click the model and choose “Center”, and it will fit.
Also, remember to disable brim!