Coaster - Printing in progress Spiral edition

This is a variant from my previous design : https://www.printables.com/model/231240-coaster-printing-in-progress

There is 2 sizes available :

• Small size is arround 95mm in diameter
• Large size is arround 105mm in diameter

You can print the parts without support, I suggest using a brim on the nozzle if you're struggling with bed adhesion, you can add a bit of superglue for a perfect joint.

The prints above are made from Prusament Chalky Blue and Pistachio Green PETG (0.16 layer height, 0.2 should be fine) and Amazon EONO silky silver PLA (0.2mm layer height).

Enjoy your drinks !

----

Want to support my work ? Check the following link ;)
Donations : http://www.paypal.me/redarhd