JumpingJeep Bobblehead

My Brother likes his Jeeps, so I decided to make a jeep Boblehead.  While I was at it, I though, why not make a bobblehead of him, bobbling on his jeep as it bobbles.  And here it is.

The Jeep is my own design, but I did take the body from the Joel bobblehead.  I scaled it down a bit, but all seems to work fine (though I did have to sand the ends of the smaller spring to get them to fit in).

In this model, I made the wheels loose, so you could take it off the base and roll it around, so I only glued the large spring to the base.  The slot at the bottom of the jeep seemed to hold well without gluing.

I broke the jeep into 2 parts, with the bottom half printing upside down.  If you can print better than I can, you can go with the jeepfull stl file.