Boba Fett's Jetpack for Lucky 13!

This is Boba Fetts jetpack with a working rocket launcher like in the movie!

It works for the lucky 13 by soozafone as well as the scout 22.

Print in only 1 hour and 10 minutes!

If you like it - like it!

Needed items:

Pen spring

Glue

Print settings:

0.15mm layer hight

PLA

10 or more infill

Brim on rocket

Support on both sides of the jetpack

Assembly instructions:

1. Print all files
2. Put the spring into one half of the jet pack and glue it to the bottom of the tube to make sure it does not fly away when shooting.
3. Glue both sides of the jetpack together.
4. Split the chest and the lower body
5. Place the jetpacks waste strap on to the ball joint of the lower body
6. Connect the upper body with the lower body again so that now the jetpack is attached to the lucky 13
7. Load the rocket by pressing it against the spring while pressing the peg into position.
8. Pull out the peg to fire!