Muin Solder Fume Extractor Riser Stand

I do a fair amount of soldering work using my desktop vise.  I purchased a Muin Solder Fume Extractor (available on Amazon) & found that it was fine for soldering items on the desktop but not when they are in the vise.  So I designed this simple riser to raise the Extractor up 120 mm so that it was at a height equal to my vise.  The riser has depressions for the Muin's four feet and when the Extractor is in the riser, it fits snugly into the top.

I printed this with supports and then left the supports in my print but you can easily pull the supports out from beneath the unit.  Standard MK3S+ settings.  Print shown was made using eSun Yellow PLA+ filament.

If you need to adjust the height for a lower rise, simply cut off from the bottom of the unit rather than scaling as scaling will adversely affect the depressions for the unit on the top.