Elephant

Well I love elephants and I hope you do too. Printed on my P1S and Sovol SV06 with 0.2 mm layer height, eSun ePLA matte grey and organic supports, sliced in Prusaslicer 2.6 Alpha.

I placed the elephant on his back(SV06), to need less supports. But i was too stingy with the supports under his trunk and that meant an injury for him! (see photos) I happened to have a spare trunk lying around  😉 and was able to repair it quickly.

The print on my P1S is just placed on the feet with 0,16 Profile and treesupports.

The tree log is printed upright with a brim and some supports to hold it.

I was too excited to wait for the painting, which I will do later.

So have fun printing and please leave a like!

(the models were revised and modified with meshmixer)

added teeth and did some remixing