House connector for HEATBED Ratrig Vcore

This is a simple design for Ratrig to make the printing plate removable easily.

The connector used is a CNLINKO LP-12 4 PIN.

https://it.aliexpress.com/item/32882630656.html?spm=a2g0o.order_list.order_list_main.132.21ef3696Z4kPKs&gatewayAdapt=glo2ita

2 Pin for bed thermistor and 2 pins for 220 V power supply

You will need to solder the wires, the connector should hold power up to about 1000 watts.

Printing requires only a few supports, to support the threaded part that goes into the panel.

After printing you should be able to move the 2 parts.

Use a 0.4 nozzle and set a flow not too wide , to allow the design to work;