Paradox Pokemon Slither Wing - Standing Upright

Pokemon Scarlet's Slither Wing, now printable!

Some warnings: this is my first time trying to fix up a model! When scaled small, the wings tend to slice with holes or badly placed retractions/seams, probably due to the wings being tapered in width. The only way I've found to fix this is to scale it up enough to where the wings are at least two/three walls thick. 

If you really want to print it small, it'd probably look fine after being sprayed + sanded with primer filler.

My settings:

• Anycubic Vyper w/ linear advance + PrusaSlicer 2.6.0a2 + Octoprint
• IIID PLA+
• Speed: 60mm/s default
• Layer height: 0.15mm walls, 0.3mm infill, 0.4mm nozzle
• 40/4mm retraction
• Arachne perimeter generation + organic supports + extra perimeters enabled
• 10% gyroid infill
• Brim + supports required