Upgrade to iPad 9Gen Holder PWR+ (iPad Air 1 to iPad 9Gen)

Getting a new iPad requires mostly new accessories, like holder. Don't throw away your old holder. Adapt it! Cut off the four bent sections, cut a 18mm wide tongue, 26mm from outer end. Crosslength shall be approx. 286mm both ways, see screenshot of TinkerCad. Diagonal lengths are 286mm each.

I had iPad Air1 and now the holder needs to fit iPad 9Gen. I cut off the ends of the original holder, designed new clamp, you need 2 defaults and 2 mirrored.

The holes in the parts are provided for M3 button head cap screws (BHCS), which are screwed in from the bottom side of the holder through the four clamps. Important that the screws are definitely shorter than the clamp, as you may run risk to scratch the rear side of your (new) iPad. Lower screws I would strongly recommend, upper two screws are an option. If you tkae the iPad often out of the holder, maybe ommit the upper screws.

Material Sainsmart black TPU.

Designed in TinkerCad.

Printed on Voron 0.1. I printed all four individually, that may save you some cleaning up from strtinging. 

Recycle → Reuse!