MKS TS35 display mount for Artillery Genius (Pro) / Sidewinder X2

I've created a mount for the MKS TS35 touch display which comes with the MKS PI. When the MKS PI is mounted inside the case it's pretty useful to have the display attached.
It also comes with a stylus holder and stylus.

To mount this you need to drill two holes. I removed the old display to have a hole for the ribbon cable. Hold the frame where you want to mount it, mark the two holes at the top and drill through the metal using a 3mm drill (or slightly bigger).
You also need 2 M3 screws with at least 15mm length and 2 short M3 screws, also 4 M3 nuts.
Place the display into the frame, it should fit tight, use the short screws to mount the display to the frame using the two bottom holes. Then be careful to not break the two clip noses when placing the display frame onto the base.

Print it with the display side to the bed, no supports needed.

I've added the .f3d file for editing using Fusion 360.