Prusa (Black) Delta Power Supply Plug & Play Cover

I was already trying to come up with some kind of quick connection when I found the Big Einsy Case Plug & Play - By Marv Which was perfect for what I was looking for. Unfortunately, nobody had a quick connect set up for the power supply.

Needed:

• 2x original power cables from Prusa
• 2x XT60E-M power connectors (Amazon link)
• 4x 2.5mm X 10mm flat head hex bolts
• Shrink Tubing
• The ability to solder the connections

After printing, you will need to trim the power cables that go to the power supply side (blue connectors) of the cable to roughly 80mm. 

Solder the connector onto the cable paying attention to positive or negative sides of the connector to match the red and black cable. 

Before you can attach the connectors to the printed part, you need to pick the direction you want your connectors pointing. Then trim one inside ear off that will be facing the other connector. see picture above.

The last thing you need to do is screw down your terminals and bend the fork connector up to about a 45° angle and screw your connectors into the printed part. 

Placed the cover on like you would the original use 2x 3mm x 10mm bolts to secure the cover and you’re done.
 

Any feedback would be greatly appreciated.