[ENG]
Simple tow truck with folding ramp and rotating wheels printable in one piece without supports. The model is designed for printing on the side when all parts (car, wheels and ramp) are printed at once. The model can be printed both in basic size and in enlarged versions, where even at double magnification it achieves sufficient detail to be interesting. After printing, the model needs to be "moved around". For the wheels, just grab them from both sides and gently rotate them in the axis. For the ramp, the rotation axis needs to be taken into account when moving. For the basic version, there is no harm if the through axle is torn away from the ramp, as its joint is shaped into cones embedded in the car body for such cases. In the case of enlarged variants, this pass-through axis is usually also released. The towing car is designed to carry my previous model "Skoda 120", which I also include here for simplicity.
ATTENTION, the model contains small parts, so it is not suitable for small children.
More toys printed in one piece:
Truck - tanker - https://www.printables.com/cs/model/255294
Little Bobcat - https://www.printables.com/cs/model/236978
Small tractor - https://www.printables.com/cs/model/233171
RM-70 Vampire 4D - https://www.printables.com/cs/model/210683
Flexi excavator - https://www.printables.com/cs/model/233416
Tatra 813 KOLOS - https://www.printables.com/cs/model/204992
Small truck - https://www.printables.com/cs/model/203724
Little beton mixer truck - https://www.printables.com/cs/model/86386
Small car - https://www.printables.com/cs/model/85918
Small van - https://www.printables.com/cs/model/85917
[CZ]
Jednoduchý odtahový vůz se sklopnou rampou a otáčejícími koly tisknutelný v jednom kuse bez podpor. Model je navržen pro tisk na boku kdy se tisknou všechny části (vůz, kola a rampa) najednou. Model se dá tisknou jak v základní velikosti tak i ve zvětšených variantách, kdy i při dvojnásobném zvětšení dosahuje dostatečné detaily aby byl zajímavý. Po vytištění je potřeba model „rozhýbat“. U kol stačí chytit je z obou stran a opatrně protáčet v ose. U rampy je potřeba brát při pohybu v potaz osu otáčení. U základní varianty není na škodu pokud dojde k odtržení průchozí osičky od rampy, neboť její kloub je pro tyto případy tvarován do kónusů zapuštěných do těla vozu. U zvětšených variant zpravidla dojde i k uvolnění této průchozí osy. Odtahový vůz je vytvořen pro převážení mého předchozího modelu „Škoda 120“, který zde také pro zjednodušení přikládám.
The author marked this model as their own original creation.